1. How to install costume model props?

Install the model base: insert the model support on the chassis with screws. Be sure to tighten the screws (the model will not tilt).

Installation of the lower body: put the feet with buttocks on the ground, put the model's waist against his body, and then take the other foot of the model to align with the joint, and then screw the model's lower body onto the base.

Install the upper body: connect the upper body to the lower body, twist it to fit, and then install two arms.

2. How to dress the costume model props?

Wear pants: if the distance between the two feet of the model is relatively large, one of the feet should be taken apart first, and the two feet should be put into the pants respectively, and then the feet should be installed; if the distance between the two feet of the model is not large, it is not necessary to remove the feet and put on the pants directly.

Dressing: first take apart one hand of the model, the other hand does not need to be removed (Note: if the fingers are relatively open, the palm must be removed to avoid finger fracture), and then the sleeve is put into the model's hand which has not been disassembled, then the opened model hand is inserted into another sleeve, and finally the arm is installed on the model.

Button up, zip up, and then put the clothes in order.

3. How to maintain model props?

Pay attention to the use of care, especially to avoid collision with the model joint.

When placing models in shopping malls, try to put them on the side.

The model should not be placed in the direct sunlight. The paint on the surface is easy to change color.